A DIY Sub Crossover -what would you like to see?

Collapse
This topic is closed.
X
X
Collapse
 
  • Page of 2
  • Time
  • Show
Clear All
new posts
Previous 1 2 template Next
  • cjd
    Ultra Senior Member
    • Dec 2004
    • 5568
    #46
    Yeah, i think my preference would still be to toss a cheap pot in there and dial-a-crossover, then measure the values and wire in resistors, pitching the pots into the parts pile.

    why yes, alliteration is fun.
    diVine Sound - my DIY speaker designs at diVine Audio
      • Bottom

      Comment

      • Amphiprion
        Senior Member
        • Apr 2006
        • 886
        #47
        Yes, the DIP's were to provide a binary selection of an R-2R-4R-8R... network. With 4 switched resistors and 1 fixed I could do 40-80Hz crossover selection in 2.5Hz increments.

        I think the gold over copper contacts should be fine, but I can always make a PCB decal that will fit either a 300 mil DIP switch or a 100 mil pitch dual row pin connector for jumpers, with a pot off to the side. Pick one of the three
          • Bottom

          Comment

          Previous 1 2 template Next
          Working...
          Searching...Please wait.
          An unexpected error was returned: 'Your submission could not be processed because you have logged in since the previous page was loaded.

          Please push the back button and reload the previous window.'
          An unexpected error was returned: 'Your submission could not be processed because the token has expired.

          Please push the back button and reload the previous window.'
          An internal error has occurred and the module cannot be displayed.
          There are no results that meet this criteria.
          Search Result for "|||"