Hi All,
I just read some of the posts in the Tangband thread, and the topic of aluminum baffle panels came up. I've been interested in this ever since I first saw the Aurasound NS3-193's in person- the baffle really has to be chamfered from behind to get any airspace!
I did some searching, and this was the only thread I came up with a discussion of these milled plates to support drivers with restricting baskets. Has anybody here had any luck making or using such plates?
A while ago I found a place called emachineshop.com. I don't know if they're any good, but simple parts are supposed to be fairly reasonable and the cost goes down with volume. Any experiences? Any opinions?
I just read some of the posts in the Tangband thread, and the topic of aluminum baffle panels came up. I've been interested in this ever since I first saw the Aurasound NS3-193's in person- the baffle really has to be chamfered from behind to get any airspace!
I did some searching, and this was the only thread I came up with a discussion of these milled plates to support drivers with restricting baskets. Has anybody here had any luck making or using such plates?
A while ago I found a place called emachineshop.com. I don't know if they're any good, but simple parts are supposed to be fairly reasonable and the cost goes down with volume. Any experiences? Any opinions?
Comment