Will this work for Ht/Mussic ?

[yousuredo2]

I dont have any programs or knowledge on how to use them...
but I built a box for it, based on info givin from another site, and it sounds ok...
But I am open to other sugestions...

Spec are a s follows:
Ma Audio Sub Ma10d6 (dual voice coils, 6.ohms)

FO: 29.58
QMS: 3.48
Qes: 0.47
Qts: 0.41
Vas(L): 43.97
Revc(OHm): 2.7
Spl@ 1wat/1Meter(db): 85.66
Xmax Linear PK-Pk(mm): 20
Levc @ 1k Hz(mh): 1.4

Enclosure Volumes - Sealed:
Sealed(cu.ft.): 0.5
Fill Required (%): No
3db Down point(-3db hz): 51

Maximum Sealed(cu.ft.): .75
Fill Required (%): No
3db Down point(-3db hz): 50

ENCLOSURE VOLUMES - Ported:
Vented (Cu. Ft): 2
Vented to (Hz): 34
3dB down point (-3dB Hz): 29
Port Diameter ("): 3
Port Length ("): 15.5
Number of Ports: 2

thanx for your help, sugestions...
chris

[BobEllis]

It looks like a car woofer. The question back at you is work as what?

Sealed it might be suitable as a woofer in a three way system. It doesn't go low enough to be a subwoofer.

Ported it is a deep woofer, not really a sub in my book. Judging by the part number it is a 10" driver. Even with 20 mm of xmax (assuming that distortion is acceptably low up to that point) it won't be able to move enough air to be a subwoofer in a reasonably sized room. Maybe a bedroom system would be OK with this.

If budget allows, try this http://www.zaphaudio.com/archives-20.zip Parts Express has the BASH 500W amp on sale for ~$160, for for $300+ cabinet you'd have a nice sub that goes deep.