First I would like to thank all who reply.
Wednesday morning i get all the supplies i need for the sonosub minus the subwoofer(other active thread).
I know that in every post that i read one is not to use a stock crossover, I did not know this until i began reading all the information that is availible on this forum as well as htforum. Well i have a parts express 4500hz 2 way crossover that i would like to use and need idea's for a woofer to go with this tweeter from mcm electronics titanium 30 mm High End Dome Tweeter
Specs: Power Handling: 50 W RMS/80 W Peak,
Voice Coil Diameter: 30 mm,
Impedance: 8 ohm,
Frequency Response: 1000~22 KHz,
Magnet Weight: 10 oz,
SPL: 90 dB 1W/1M,
Fs: 880 Hz
Dimensions: 4-1/4" dia. x 1-1/8"
Cutout: 3-3/16"
Any Idea's will be helpful. Prefer to keep it a 6 1/2" or smaller. I do have 4 Dayton 6 1/2" dc 160-8 but i read somewhere that they need to be crossed at 2000hz ?
Thank You All.
Wednesday morning i get all the supplies i need for the sonosub minus the subwoofer(other active thread).
I know that in every post that i read one is not to use a stock crossover, I did not know this until i began reading all the information that is availible on this forum as well as htforum. Well i have a parts express 4500hz 2 way crossover that i would like to use and need idea's for a woofer to go with this tweeter from mcm electronics titanium 30 mm High End Dome Tweeter
Specs: Power Handling: 50 W RMS/80 W Peak,
Voice Coil Diameter: 30 mm,
Impedance: 8 ohm,
Frequency Response: 1000~22 KHz,
Magnet Weight: 10 oz,
SPL: 90 dB 1W/1M,
Fs: 880 Hz
Dimensions: 4-1/4" dia. x 1-1/8"
Cutout: 3-3/16"
Any Idea's will be helpful. Prefer to keep it a 6 1/2" or smaller. I do have 4 Dayton 6 1/2" dc 160-8 but i read somewhere that they need to be crossed at 2000hz ?
Thank You All.
Comment