MDM-55 Low Impedance Help *PIC*

[Guest]

Dick and all, I don't have the LCR notchs you sent me with your design, however, I did try them at home and they don't work out to well using dual RS225s. Attached is a picture of what I have so far. How can I get that low impedance up. This carries through and the total impedance at that point is really a little less than 2ohms when all drivers are connected. I'm not much on knowing how to do this so any help to point me in the right direction appreciated. Thanks, Paul

[Gerald Jansen]

Hi paul, I would try to intercange the order of connection of low-pass and high pass part of your filter (CLC first, then RLC to MDM-55). Then you'll probably have to readjust some component values to meet the filter goal.