I am about to order all the parts for the NatP's from parts express and had a few last questions.
As far as my order-
1- Would the 3/4" 3-layer sonic barrier be OK, or should I use 1 1/4"? ($90 vs $120 @ 6 sheets)
2- Would this be good for internal crossover and external speaker wiring?
And as far as the build-
3- For a small tower are soundbites internal dimensions of 7.5”x9.5”x48” recommended?
4- On the crossover pic (below) is the cross just to the right of the .44 iinductor a intersection of the wires or are they separate?
And lastly-
5- Will my old nad 1155 amp w/ 55w X 2 be enough to drive these, or should I like for a new amp?
Thats it. Thank you all for all the work in these projects. I am really looking forward to trying my first diy speaker project. :T
As far as my order-
1- Would the 3/4" 3-layer sonic barrier be OK, or should I use 1 1/4"? ($90 vs $120 @ 6 sheets)
2- Would this be good for internal crossover and external speaker wiring?
And as far as the build-
3- For a small tower are soundbites internal dimensions of 7.5”x9.5”x48” recommended?
4- On the crossover pic (below) is the cross just to the right of the .44 iinductor a intersection of the wires or are they separate?
And lastly-
5- Will my old nad 1155 amp w/ 55w X 2 be enough to drive these, or should I like for a new amp?
Thats it. Thank you all for all the work in these projects. I am really looking forward to trying my first diy speaker project. :T
Comment