What happens when you put multiple sub drivers in a small sealed box. Can you even do this? What about a push pull arrangement. Would you get increased output? Lower distortion etc.? Those are my general questions, here are the specifics.
As many of you may know, I ordered some drivers for an IB which cant be built until I move. The new house will be done in early July but we could be moving any time because selling our current house if of key importance.
That being said, I have asked about building a dipole sub etc. but after careful consideration, it would probably be to big for my room if I use the right baffle size and could be a waste of time and money if the house sells a week after getting it built.
But, I still would like to play around with the drivers if I could, so I thought about putting two of them in my current box (130L sealed box). What will happen if I do? Is this going to kill my drivers or explode the box? I would put the drivers on opposite walls of the box as the wall opposite the current driver could have a hole cut in it with no problems and no needs for mods to the current bracing design. What happens if I put two drivers in there and wire them electrically in phase? What happens if I put two drivers in there and wire them electrically out of phase but then they'd be in a push pull configuration.
Am I totally crazy, should I just test the drivers and then put them away? What would I gain by putting two of them in the current box?
As many of you may know, I ordered some drivers for an IB which cant be built until I move. The new house will be done in early July but we could be moving any time because selling our current house if of key importance.
That being said, I have asked about building a dipole sub etc. but after careful consideration, it would probably be to big for my room if I use the right baffle size and could be a waste of time and money if the house sells a week after getting it built.
But, I still would like to play around with the drivers if I could, so I thought about putting two of them in my current box (130L sealed box). What will happen if I do? Is this going to kill my drivers or explode the box? I would put the drivers on opposite walls of the box as the wall opposite the current driver could have a hole cut in it with no problems and no needs for mods to the current bracing design. What happens if I put two drivers in there and wire them electrically in phase? What happens if I put two drivers in there and wire them electrically out of phase but then they'd be in a push pull configuration.
Am I totally crazy, should I just test the drivers and then put them away? What would I gain by putting two of them in the current box?
Comment