I am a Rotel newbie(upgrade from an Onkyo 575X), so here goes...
I have a question regarding bass management on the 1065:
Manual says: Use YES setting if your system has a subwoofer.
I take this to mean that frequencies below the selected crossover point are directed to the sub form any speaker not specified as LARGE.
Manual says: Select the MAX setting to redirect all low frequency information from all speakers (including LARGE speakers) to the sub.
Does this mean that the speakers set to large reproduce bass below the selected crossover point (full range), and that those lower frequencies are ALSO produced by the sub, therefore possibly increasing the entire bass output of the system?
Thanks for any answers.
I have a question regarding bass management on the 1065:
Manual says: Use YES setting if your system has a subwoofer.
I take this to mean that frequencies below the selected crossover point are directed to the sub form any speaker not specified as LARGE.
Manual says: Select the MAX setting to redirect all low frequency information from all speakers (including LARGE speakers) to the sub.
Does this mean that the speakers set to large reproduce bass below the selected crossover point (full range), and that those lower frequencies are ALSO produced by the sub, therefore possibly increasing the entire bass output of the system?
Thanks for any answers.
Comment