Hi there.
Rotel RCX-1500 cratered during software update from V1.15 to V1.23.
Was running "ymodem" upgrade manager and switched RS232 cable with DB-9 to RJ-45 and unit just powered off / died (no standby light) tried hard power reset to no avail.
Checked mains fuse and it is intact.
Tried different power cable and outlet all with no result. Unit will not power. Standby light will not come on.
All actions are done in accordance with the instructions: "RCX1500_Main_Update_Instructions.PDF"
My connection: USB to COM1 -- COM1 to RJ-45.
Baud Rate - 115200
Parity - N
Valid Data Bits - 8
Stop Bit Value - 1
Handshaking - None
On the Internet I found similar problems in other Member Rotel RCX-1500 (but I have not found the solution).
Please help me to solve this problem remotely.
Rotel RCX-1500 cratered during software update from V1.15 to V1.23.
Was running "ymodem" upgrade manager and switched RS232 cable with DB-9 to RJ-45 and unit just powered off / died (no standby light) tried hard power reset to no avail.
Checked mains fuse and it is intact.
Tried different power cable and outlet all with no result. Unit will not power. Standby light will not come on.
All actions are done in accordance with the instructions: "RCX1500_Main_Update_Instructions.PDF"
My connection: USB to COM1 -- COM1 to RJ-45.
Baud Rate - 115200
Parity - N
Valid Data Bits - 8
Stop Bit Value - 1
Handshaking - None
On the Internet I found similar problems in other Member Rotel RCX-1500 (but I have not found the solution).
Please help me to solve this problem remotely.