So,
I just ordered the North Creek crossovers for my Matrix 802S2 speakers. Which of the following is it best to do?
1) Install the Northcross crossover as they recommend, leaving in the old wire?
2) Rewire the 802's from the drivers to the connectors on the back of the speakers?
3) Rewire the 802s from the drivers to the crossover, using a hole on the bottom of the speaker to pass the wires?
My other question would be, how should I run the wire to the tweeter. The tweeters have a wire sticking out of them with a special connector. Should I leave the connector on and try to get a new connector for the new wire. Should I solder the 2 wires together (not my first choice. Should I use some other type of connector?
Thanks for your help,
Dave
I just ordered the North Creek crossovers for my Matrix 802S2 speakers. Which of the following is it best to do?
1) Install the Northcross crossover as they recommend, leaving in the old wire?
2) Rewire the 802's from the drivers to the connectors on the back of the speakers?
3) Rewire the 802s from the drivers to the crossover, using a hole on the bottom of the speaker to pass the wires?
My other question would be, how should I run the wire to the tweeter. The tweeters have a wire sticking out of them with a special connector. Should I leave the connector on and try to get a new connector for the new wire. Should I solder the 2 wires together (not my first choice. Should I use some other type of connector?
Thanks for your help,
Dave
Comment